The traffic light manufacturer detailed the road to see if the traffic lights were turned

Traffic signal manufacturer to talk, the vehicle should pay attention to the following aspects when turning around:

There is a turning point

No matter what kind of intersection, if have special turn indicator or the ground line, all in accordance with the lamp and the floor marking instructions, usually in the far left, of course, there are a bit strange flower set the logo on the right side.

There are no turning lights and turn left lights

Generally speaking, the logo or simply not to stop turn around turn around alone under the condition of light, motor vehicle can travel without affecting normal vehicle and to ensure the safety of cases turn at any time. Usually the center of the journey is turned from the solid line to the dotted line at the next corner, and the vehicle can turn around in the area.

Yellow grid area

The yellow grid area represents a stop stop, and if a red light is in front, the rear vehicle should take away from the area. But turning around in the area was promised, with no barrier in the center, and a motor vehicle capable of turning around in the area.

The zebra crossing area

Some way of painting a zebra crossing, although this area is usually does not stop turning, but the area is equal to the pavement, is sure not to turn around.

There is no "stop" sign that promises to turn around

When you go to the intersection, there is no sign of "stop turning left" or "stop turning," the driver can turn around and turn around without paying attention to the traffic lights. If crossroads have obvious signs, write a "left turn when the green light", "red light", such as words, turn around when the road traffic lights at home, must follow the clues of the convention.